Showing results of measurements

You can show the result attributes of the following evaluations as a list:

• Data collection measurements derived from data collection points
• Delay measurements derived from vehicle travel time measurements
• Area measurements derived from sections

The result attributes can have sub-attributes. You can then filter the display of data in the list.

1.  On the Lists menu, click Results and then select the desired result list:

• Data Collection Results (Evaluating data collection measurements)
• Delay Results (Showing delay measurements in lists)
• Area Measurement Results (Evaluating pedestrian areas with area measurements)

The result list opens.

2.  Click the Attribute selection button  (Selecting attributes and subattributes for columns of a list).

3.  In the section on the left, select the attributes of your choice (Selecting attributes and subattributes for columns of a list).

4.  If desired, click the Filter button and filter the data (Setting a filter for selection of subattributes displayed).

5.  If you have filtered data, in the Attribute filter window, confirm with OK.

The result attributes from the simulation are shown in the results list (Evaluating pedestrian areas with area measurements), (Evaluating data collection measurements), (Showing delay measurements in lists). A column with result attributes is shown for each filtered sub-attribute. If you start the simulation again, the average, standard deviation, minimum and maximum values of the simulation data are also shown. You can save the result list to an attribute file *.att (List toolbar).