Showing result attributes in result lists

Result lists show the values of the attributes Simulation run and Time interval as well as network object-specific attributes from the simulation. You can save result lists to an attribute file *.att (List toolbar).

If you perform multiple simulation runs, these are shown in succession in the result lists.

1.  Configure the desired evaluation of result attributes (Configuring evaluations of the result attributes for lists).

2.  On the menu Evaluation > Result Lists, click the desired entry.

The result list opens.

3.  If you wish to change the selection of the attributes in the list, click the Attribute selection button  (Selecting attributes and subattributes for columns of a list).

4.  In the section on the left, select the attributes of your choice (Selecting attributes and subattributes for columns of a list).

5.  If desired, click the Filter button and filter the data (Setting a filter for selection of subattributes displayed).

6.  If you have filtered data, in the Attribute filter window, confirm with OK.

7.  Start the simulation (Running a simulation).

The data from the simulation is shown in the result list. You can switch between the open program elements, for example, between various lists and network editors. You can show result attributes in result lists after a simulation, provided that you selected and configured the corresponding evaluation before the start.

8.  Make the desired changes (List toolbar).

Element	Name	Description
	Show Simulation Run Aggregates	Shows the following aggregated values for some network object types in the result list or hides them: Mean Minimum Maximum Standard deviation Percentile
	Show Time Interval Aggregates	Shows the aggregated values across all time intervals for some network object types in the result list or hides them, if several time intervals are defined.