Selecting and copying network objects

1.  Select the desired network objects in the Network Editor (Moving network objects in the Network Editor).

2.  If you have selected dependent network objects with a From Section and a To Section that both lie on stand-alone network objects, make sure that you also select the stand-alone network objects.

3.  If you have selected vehicle routes or PT lines, make sure that you also select all the links used by the vehicle routes or PT lines.

4.  If you have selected connectors, make sure that you also select the origin and destination links.

5.  If you have selected conflict areas, make sure that you also select all links that traverse the conflict areas.

6.  Right-click in the Network editor.

7.  On the shortcut menu, click Copy.

Tips:   Alternatively, use the following commands to copy network objects to the Clipboard: Hotkey Ctrl+C Hotkey Ctrl+Ins Network Editor toolbar > Copy selection You can also duplicate network objects in the Network editor (Duplicating network objects)

The selected network objects are copied to the Clipboard. Together with the network objects, base data that refers to the network objects is copied.

8.  If you have copied network objects with a file reference via a relative path, before inserting them into another Vissim network, make sure that the relative paths specified are also valid for the other Vissim network.

9.  If desired, continue to edit the Vissim network.

10.  Insert the copied network objects (Pasting network objects from the Clipboard).