Attributes of parking routes

► On the Lists menu, click > Private Transport > Routes > Parking Routes.

The list of attributes opens.

The attribute and attribute values of this network object type are shown in the list on the left, which consists of two coupled lists.

Note: In lists, you can use the Attribute selection icon to show and hide attribute values (Selecting attributes and subattributes for columns of a list).

The list on the left may include the following attributes:

Column	Description
VehRoutDec	Vehicle routing decision: Number and name of the parking routing decision of the parking route
No	Number of parking route
Name	Description
ParkLot	Parking lot: Name of parking lot Additional attributes: (Modeling parking lots)
ParkDir	Parking direction: Direction of driving when parking and leaving a parking space. Determined by Vissim from the direction of the connector leading to the parking lot. Invalid: Parking direction Forward or Reverse is not possible: The value of the Parking direction attribute of a parking lot does not match the value of the Reverse parking attribute of the connector leading to this parking lot. For example, there is a contradiction if Forward parking is selected for the parking lot and the Reverse parking attribute is selected at the connector that the vehicle is to use for parking.
RelFlowSameParkLot	Relative flow for same parking lot: Share of this route in all routes of the same routing to the same parking lot. Effective only if there is more than one possible route to the same parking lot. This can be used, for example, to set the ratio between forward parking and reverse parking of a parking lot.
SmthDist	Smoothing distance: A value > 0 activates a smoothed lateral correction of the rear axle(s) of a parking vehicle, so as to avoid visible jumps in the course of travel. The correction ends at the turning point at which the vehicle changes between forward gear and reverse gear, regardless of whether the vehicle is pulling forward or backing into a parking lot. The smoothing distance determines how far before this turning point the correction starts. Default values: parking routes for forward parking: 3.0 m. parking routes for reverse parking, in the last three parking spaces before the end of a dead end: 3.0 m, all others: 20.0 m.. parking routes for reverse parking, if the drive aisle is not a dead end: 20.0 m.

Showing and editing dependent objects as relation

1. In the list on the left, click the desired entry.

The list on the right contains attributes and attribute values of network objects, and/or base data allocated to the network object selected in the list on the left (Using coupled lists):

2. On the list toolbar, in the Relations list box, click > Link sequence.

Attributes of link sequence are displayed: Numbers of links and connectors via which the route leads (Attributes of links)

3. Enter the desired data.

Superordinate topic:

Modeling vehicle routes, partial vehicle routes, and routing decisions

Information on editing:

Defining static vehicle routes

Combining static routes

Defining parking routes

Defining a vehicle route of the type managed lane

Modeling a separate route course for the toll route and toll-free route

Defining a vehicle route of the type closure

Defining partial vehicle routes

Defining a partial route based on an existing partial route

Inserting intermediate points into a vehicle route

Changing routing procedure via intermediate points

Defining a vehicle route based on an existing vehicle route

Moving routing decisions or destination sections

Deleting vehicle routes, partial vehicle routes, and routing decisions

Checking and repairing routes