Displaying vehicle journeys in the schematic line diagram
You can select the vehicle journeys that you want to display in the schematic line diagram as follows.
- ► On the toolbar, click the icon.
Tip: Alternatively, from the Schematic line diagram menu, select the Edit vehicle journey selection entry. |
The Vehicle journey selection window opens. Depending on your settings, the list either contains all lines or all lines, line routes, time profiles and vehicle journeys which are contained in the network (Setting the layout for schematic line diagrams).
Selecting lines whose vehicle journeys shall be displayed
1. Select the lines whose vehicle journeys you want to display in the schematic line diagram.
Element |
Description |
|
Switch on or off that only active lines are shown in the navigator (Using filters to set network objects active or passive and Setting network objects active/passive via the spatial selection).. Right-click the icon to open the filter editing window for lines. Note The function is activated if the icon is pressed (red). |
|
Show all served stops of the vehicle journeys of marked directional lines as transfer nodes |
|
Display start and end stops of marked lines as transfer nodes |
|
Select all lines/directions that exist in the network |
|
Select no lines/directions |
|
Invert the current selection |
2. Confirm with OK.
The vehicle journeys of the selected lines are displayed in the schematic line diagram.
Selecting vehicle journeys that shall be displayed
1. Select the lines, line routes, time profiles, directions, and vehicle journeys that you want to display in the schematic line diagram.
Element |
Description |
|
Switch on/off that only active vehicle journeys will be displayed in the navigator (Using filters to set network objects active or passive and Setting network objects active/passive via the spatial selection). Right-click the icon to open the window for editing filters for vehicle journeys. Note The function is activated if the icon is pressed (red). |
|
Show all served stops of the marked vehicle journeys as transfer nodes |
|
Show start and end stops of the marked vehicle journeys as transfer nodes |
|
Select all vehicle journeys that exist in the network |
|
Select no vehicle journeys |
|
Invert the current selection |
|
Show vehicle journeys of a specific time slot Note The icon opens a new window. Here you can specify a time slot and filter conditions. Vehicle journeys that comply with the filter conditions can be selected, deselected or exclusively selected. Valid day Select the valid day Start time/End time Enter a start time and an end time for the time slot Filter condition Here you can pick one of the following conditions:
Vehicle journeys that fulfull the filter conditions Here you can specify if the vehicle journeys that meet the filter criteria will be displayed.
If the option is selected, the vehicle journeys that comply with the filter conditions will be selected in addition to the already selected vehicle journeys.
If the option is selected, the vehicle journeys that comply with the filter conditions will be removed from the selection.
If the option is selected, only the vehicle journeys that comply with the filter conditions will be selected. All others will be removed from the selection.
If this option is selected, the selected vehicle journeys remain selected. All vehicle journeys that do not comply with the filter conditions will be removed from the selection. |
Preview / Undo |
The Preview button becomes active if you change the current selection. If you click the Preview button, the label of the button changes to Undo. You can then undo the last change or edit the selection again. If you edit the selection, the label of the button changes to Undo again. |
2. Confirm with OK.
The selected vehicle journeys are displayed in the schematic line diagram.