Within the scope of the node impedance calculation using ICA, you can optimize the signal cycle and split for an individual signal controller (Fundamentals: Signal time optimization).
|
Notes: The optimization is always done for all (main) nodes of a signal controller. The settings under menu Calculate > General procedure settings > entry PrT settings > Signal cycle and split optimization apply (Optimizing signal cycle and split times for active nodes). You can also execute the signal cycle and split optimization for multiple or all active nodes (Updating impedances at nodes and Optimizing signal cycle and split times for active nodes). |
1. Make sure that the desired main node is open in the junction editor.
2. On the junction editor toolbar, click the small triangle next to the 
symbol and select the 
ICA signal cycle and split optimization entry.
|
Note: The button is disabled if the ICA calculation is not possible for the node (Checking the status of ICA calculations). |
The ICA calculations and optimizations are done for all nodes that are allocated to the signal controller.
