Modifications are applied in a specific order that is indicated through a number in the LoadOrder column. In a scenario, the modifications are applied in this order. You can change the order of modifications. However, thereby a dependent modification must always be listed after the modifications it is dependent on.
|
Note: To avoid error messages when loading scenarios, you should first check the dependencies of modifications before you change the order they are applied in (Checking modifications). |
1. Make sure the desired project is open (Editing basic settings of the project).
2. In the Edit project window, click the Modifications tab.
3. In the list, click the modification of your choice.
4. Then click the 
Move modification downwards or 
Move modification upwards symbol.
|
Tip: Alternatively, you can change the order by manually adjusting the numbering in the Load order column as required. |
The position of the modification in the order is changed. To check the current position of a modification, look at its number in the LoadOrder column.
