You can only mark a line in the network if at least one line route and thus a course has been allocated to the line.
1. In the Network editor window, click the Edit mode icon 
.
2. In the Network window, click the Lines button.
The Lines window opens.
|
Note: Depending on the selected option, the name of the Lines/Line routes window changes. |
3. Make sure that the Lines option has been selected.
4. If required, restrict the number of lines that are displayed.
|
Element |
Description |
|
Only active ones |
|
If the option has been selected, only active lines are displayed.
If the option has not been selected, all lines will be taken into account.5. In the Lines window click one line in the list. If you want to mark additional lines, press the Ctrl key and keep it pressed. One by one, click the lines you want to mark.
|
Tip: You can also use the input field to mark the line you are looking for. To do this, enter the name of the line in the field. The line is marked in the list. |
The marked lines' line route courses are highlighted in the network. Below the list you see a value (for example: 1(11)) that specifies the number of lines you have marked and the number of all lines.
6. If required, click the Zoom button.
The current display of the network section is adjusted and the marked lines are in the middle of the network section.
|
Tips: If you want to remove all marked lines from the selection, click the Reset selection button. You can also mark the line route courses of a line if you click on a stop point in the network which is traversed by a line route of the line. Alternatively, you can mark a line by selecting the respective row in the list of lines (Selecting list sections). |
