In the Visum procedure sequence, you can automatically change the signal programs of Vissig signal controllers. Visum transfers the time and the calendar day to the Vissig editor. The signal controller editor returns to Visum the number of the particular signal program and the green times. Visum then converts all signal controllers to the signal program that is valid at that time. If no signal program exists for the chosen time, the signal controller will be switched off.
1. On the toolbar, click the 
Open 'Procedure sequence' window button.
The Procedure sequence window opens.
2. Select the desired position in the procedure sequence and add the procedure Set signal programs from the Assignments category.
3. Make sure that the inserted operation is marked and click the Edit button in the Operations section.
The Set signal programs window opens.
4. Enter the time and calendar day of the desired signal program.
|
Note: The signal programs are also reset accordingly for controllers of the RBC type. |
5. Confirm with OK.
6. Execute the procedure (Executing procedures in the procedure sequence).
The signal programs of all signal controllers are set to the signal program active at the set time on the calendar day.
