In Visum, just one signal program is allocated to a signal controller. If a signal controller has several signal programs in the junction editor, only the currently allocated signal program is displayed in the junction editor. You can switch to another signal program or switch off the signal controller.
1. Open the Signal timing view of the junction editor (Junction editor and signal control).
2. In the Switch signal program drop-down list, select the desired signal program.
|
Tip: Alternatively, you can change the signal program on the Basis tab of the Edit signal controller window (Properties and options of signal controllers). |
The signal program is changed. The signal timing is displayed in the lower section of the junction editor. The currently selected signal program is taken into account by the concerned procedures, i.e. assignment with ICA, signal cycle and split optimization, and signal offset optimization.
