|
Note: You can only mark a path set in the network if at least one path, i.e. a course, has been allocated to the path set. |
1. In the Network editor window, click the Edit mode icon 
.
2. In the Network window, click the PrT paths button.
The Paths window opens.
|
Note: Depending on the selected option, the name of the Paths/Path sets window changes. |
3. Make sure that the Path sets option has been selected.
4. Select the desired path sets in the list.
|
Tip: You can also select single path sets via the input field. To do this, enter the name of the path set in the field. The path set is selected in the list. |
All path courses of the path sets are marked in the network.
5. If required, click the Zoom button.
The network section is enlarged and the marked path sets are positioned in the middle of the section.
|
Notes: If you want to remove the previously marked path sets from the selection, click the Initialize button. You can also mark the path courses of a path set by clicking a node in the network which is traversed by a path or a path set. |
