The calculation is performed according to either HCM 2010, HCM 6th Edition (Fundamentals: Roundabouts according to the HCM method ) or TRL/Kimber (Fundamentals: Roundabouts according to the TRL/Kimber method).
1. Make sure that the values of the input attributes are correct at the nodes with control type Roundabout.
- Input attributes for calculation based on HCM (Fundamentals: Roundabouts according to the HCM method )
- Input attributes for calculation based on TRL/Kimber (Fundamentals: Roundabouts according to the TRL/Kimber method)
2. Check and adjust the parameters on the Roundabout page.
|
Element |
Description |
|
HCM |
Select this option for an impedance calculation based on the HCM 2010 (Fundamentals: Roundabouts according to the HCM method ). |
|
HCM 6th Edition |
Select this option for an impedance calculation based on the HCM 6th Edition (Fundamentals: Roundabouts according to the HCM method ). |
|
TRL/Kimber |
Select this option for an impedance calculation according to the TRL/Kimber method (Fundamentals: Roundabouts according to the TRL/Kimber method). |
|
Maximum tCur |
If this option has been checked, enter a value which is used as user-defined maximum turn penalty at the node. |
