Selecting a network object from superimposed network objects

If several network objects are superimposed in a Network Editor, you can select these consecutively. This facilitates, for example, the addition of new network objects on a desired link.

1.  On the Network Editor, click on the position at which several network objects are superimposed.

The button is active in the network editor toolbar.

2.  Click the button until the desired network object is selected.

Tips:  

  • Alternatively you can use the Tab key.
  • You can also press the Tab key to consecutively select the superimposed network objects:
  • while holding down the right mouse button and the Ctrl key to add a new network object to the desired network object.
  • while moving one of the following network objects to the area or ramp above or below:
  • Pedestrian input
  • Pedestrian routing decision
  • Intermediate point of a pedestrian route
  • Travel time measurement
  • Pedestrian Attribute Decision

Superordinate topic:

Displaying and selecting network objects