Showing data about paths of dynamic assignment in lists

You can show data about paths from dynamic assignment in lists.

Note: The Paths list can only be displayed using the add-on module Dynamic Assignment (Using dynamic assignment).

You can save the following data and data formats:

Output	ASCII file	MDB table	Attribute file from attribute list
Aggregated data	-	-
Raw data	-	-	-

Show result attributes in attribute lists (Displaying result attributes in attribute lists)
Show result attributes in a result list (Showing result attributes in result lists)

Results of path evaluation

The Paths results list contains the following attributes:

Result attribute Long name	Short name	Definition
Volume (old)	VolOld	Number of vehicles started on the path, including all vehicle types and/or each vehicle type selected during the last iteration for which the Path file was updated.
Volume (new)	VolNew	Number of vehicles started on the path, including all vehicle types and/or each vehicle type selected during the current iteration for which the Path file was updated.
Distance	Dist	Distance
Is detour	Is detour	Path is a detour
Edge sequence	EdgeSeq	Number of edges in sequence
Edge travel time (old)	EdgeTravTmOld	Travel Time on the edges of the last iteration for which the Path file was updated.
Edge travel time (new)	EdgeTravTmNew	Travel Time on the edges of the current iteration for which the Path file was updated.
Converged	Conv	Path converged
To parking lot	ToParkLot	Number of To parking lot
Number	No	Number of path
Static cost	StaticCost	Static cost
Path travel time (new)	PathTravTmNew	Determined average travel time of path: prior to a simulation run: smoothed travel time, aggregated from path file by departure time during a simulation run: changing, incomplete, newly recorded average travel time after a simulation run: travel time smoothed again with the average newly recorded travel time of all vehicles on this path and aggregated by departure time.
Path-travel time (old)	PathTravTmOld	Travel time of previous simulation run, from the start of the simulation run. This value can be used for path search, if in the Dynamic assignment: Parameters window, in the Choice tab, you selected Use volume (old) (Attributes for the trip chain file, matrices, path file and cost file).
From dynamic vehicle routing decision	FromDynVehRoutDec	Number of last dynamic routing decision of path
From parking lot	FromParkLot	Number of From parking lot
Route guidance vehicle	DestinationVeh	Number of route guidance vehicle

Superordinate topic:

Configuring evaluations of the result attributes for lists